FAQ

Can I use TakkTile sensors to measure force?
TakkTile sensors are not designed to be force sensors. However, it is possible to calibrate them to measure force. To do so, you will need a setup that allows the load to be applied to the same location repeatably. This is because the output of the sensor is dependent on location. The sensors are more sensitive at the the center than they are at the edge.

Do you calibrate the TakkTile sensors?
No. If you wish to calibrate the sensors you will need to do this yourself.

Can I use the pressure calibration provided for the MPL115A?
The pressure calibration provided for the barometer assumes you are using the device to measure barometric pressure as it was designed to do. Once the barometers are molded in rubber this calibration is no longer valid.

Specific questions please send to:

moc.scitobordnahthgir|troppus#moc.scitobordnahthgir|troppus

wordpress com stats

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-NonCommercial 3.0 License